Bitfenix Phenom Mini-ITX Manuel d'utilisateur

Quick Installation Guide

Front Fan Installaonb. Install fans (If necessary, remove FlexCage™)c. Secure with screwsa. Remove front panel by pushing tabs from inside chassis 0

a. b.Install fan Secure with screwsRear Fan Installaon10

FlexCage™ Hard Disk RackRemoving FlexCage™b. Remove screws from boom of HDD cagea. Remove plasc railb. Pull to removea. Press tabs on HDD cage11

Rotang FlexCage™b. Secure screws from boom of HDD cagea. Remove and rotate the HDD caged. Insert HDD cage from other sidec. Rotate the plasc rail a

Power Supply Installaonb. Secure PSU Back Plate on PSU (Standardscrew 6-32 hex)a. Remove PSU Back Plated. Secure with screwsc. Slide PSU into plac

a.c.b. Use A or B depending on deviced. Secure with screws (Thumbscrews M3)A BInstall device using M3*5mm RoundscrewsSlide tray into placeInstalling 5

PSU FilterPSU Filter15

Ver 1.0 : 2013/09Bitfenix Co., Ltd.3F, No.79, Sec. 1, Xintai 5th Rd., Xi Zhi District, New Taipei City, Taiwan, R.O.C.For the most updated information

Box Contents* Contents and specificaons subject to change without noce.• Phenom Mini-ITX Case• Phenom Mini-ITX Quick Installaon Guideo Screws: Thum

Removing side panelsa. Remove side panelsb.Remove thumbscrewsBasic InstallaonFront Top Back Sideab02

d. If needed, add extra 6-32*10mm Round screw for increased stabilityInstalling 3.5" drivesa. Remove hard disk tray b. Install drive by be

b. Install drive using M3*5mm Round screwsc. Slide tray into place a. Remove hard disk tray Installing 2.5" drives04

a. Remove FlexCage™ and posiondrive(s) on PSU cage c. Remove FlexCage™ and posiondrive on floord. Secure with screws (M3*5mm Round)b. Secure with scr

Installing 2.5" drivesa. Slide drives into place b. Secure with screws (M3*5mm Round)06

D. Reset buonB. Headphone jackC. Microphone jackA. SuperSpeed USB3.0 portsE. Power buonDEABC07

a. b.Remove top filter Install fansc. Secure with screwsTop Fan Installaon (120mm)d. Replace top filter08